Honda ATV Forum banner

Winch wiring on same side as exhaust ok?

3543 Views 12 Replies 7 Participants Last post by  Green
Hey all,
2007 Rancher 420. Just got my winch and looks like the motor is going to be on the LEFT side of the machine. My main winch wires (goes from winch back to actuator) are BARELY long enough to reach if I route them along the left frame. I'd like to go along the right frame, but too short. My concern is that the exhaust is on the left side. Am I worrying for nothing? There are some other wires and components along that side of the frame and seem to be ok.
If the wires were longer, I'd just route along the right side...but then again, longer wires present problems of their own.

Of you guys out there with 420's...what side of the machine is your winch wiring on?
Thanks in advance!
1 - 2 of 13 Posts
i don't own a 420..but..if i had no choice but to run the wires down that side..i'd one..make sure it was as far as posible from the ex..and two..i'd buy some wire loom's ribbed plastic..split down the may save you from a melt down on your wires.
i would not like my winch hot all the time either..just think..if you sank it below water..would this not short it out ..and blow fuses ??..nope..i would want mine hot when i use the mini rocker switch.
1 - 2 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.