[bleedhonda3]

I have a 98 foreman trx400fw and it have a brand new top end and carb with a stage one jet kit and a snorkel with a factory air filter. The carb is adjusted to specs for the mods I have and the bike chokes when you give it gas. If you choke it it will run fine but idle high and I know your not supposed to do that. It smells like old 2 stroke fuel and smokes a little even tho the top end is brand new. I'm at a loss idk what else to do


Sent from my iPhone using Tapatalk

 

[bleedhonda3]

It could be but its jetted specifically for my altitude and everything. Plus I can't find any jets at all for this carb except a dyno jet kit put together after you tell them your attitude and mods


Sent from my iPhone using Tapatalk

 

[bleedhonda3]

None of it works right lol I can't find anywhere to buy different jets to even try anything else


Sent from my iPhone using Tapatalk

 

[bleedhonda3]

I'm less than 300 ft above SL. I can't find anything but main jets and stock rebuild kits anywhere.


Sent from my iPhone using Tapatalk

 

[bleedhonda3]

Stock it did the exact same thing


Sent from my iPhone using Tapatalk

 

[bleedhonda3]

You may be right because I have changed the carb assuming that it would still be factory specs. I can take the jets out of the old carb and install them in the new carb?


Sent from my iPhone using Tapatalk

 

[bleedhonda3]

Ok I took the pilot jet the main jet and the emulsion tube out of the factory carb along with the needle. I reinstalled the factory washer above the c clip along with the extra washer supplied in my jet kit. The main jet out of the stock carb was much larger than the one in the jet kit for some reason anyways it fires up and idles easy and idles fine not choked and the bad fuel smell is pretty much gone. Now the only problem is I choked it back fires a little and won't take much throttle so I'm assuming I just need to play with the air fuel screw


Sent from my iPhone using Tapatalk

 

[bleedhonda3]

Well now nomatter where the air fuel screw is set it doesn the same thing... It won't take much throttle not choked...


Sent from my iPhone using Tapatalk

 

[bleedhonda3]

It is an oem carb and the original one was corroded inside cause the bike was abused


Sent from my iPhone using Tapatalk

 

[bleedhonda3]

There was no fixing it


Sent from my iPhone using Tapatalk