Honda ATV Forum banner

valve adjustment procedures

3423 Views 5 Replies 3 Participants Last post by  Helmut

have a 2006 Rancher 350. Have not adjusted the valves. Think maybe I should. Can anyone tell me the procedures or tell me where I can find them on the site.

New to the site so I hope I have not done anything stupid

1 - 2 of 6 Posts
Welcome to the forums. When you line the "T" mark up to put the piston on TDC, you can be on the compression stroke or the exhaust stroke. Make sure you are on the compression stroke to adjust the valves. Also, make sure the engine is completely cold. The following comes from a 2000-2003 service manual, but it will be the same procedure.

See less See more
You're welcome.
1 - 2 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.