Honda ATV Forum banner

Two swing arm mounts?

4391 Views 5 Replies 4 Participants Last post by  TennesseeCountryBoy
Changed the swing arm bearings in my bosses 08/09 420 today, when I was refitting the swing arm I noticed a second set of holes on the frame about an inch below the mounts. What are these for?
I did consider bolting it back together using the lower holes to see if there was any noticeable differences other than a slight lift, I decided against thatbin the end and put it back together as it should be.


See less See more
1 - 2 of 6 Posts
Ahh ok, never thought about IRS mountings, good call Jeep :)

Thanks for clearing that up.
1 - 2 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.