If you put it in the lower holes I'd say it would put your drive shaft in a major bind. It's for the subframe for irs machines
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Two swing arm mounts?
Changed the swing arm bearings in my bosses 08/09 420 today, when I was refitting the swing arm I noticed a second set of holes on the frame about an inch below the mounts. What are these for?
I did consider bolting it back together using the lower holes to see if there was any noticeable differences other than a slight lift, I decided against thatbin the end and put it back together as it should be.
I did consider bolting it back together using the lower holes to see if there was any noticeable differences other than a slight lift, I decided against thatbin the end and put it back together as it should be.
