Honda ATV Forum banner

Two swing arm mounts?

4400 Views 5 Replies 4 Participants Last post by  TennesseeCountryBoy
Changed the swing arm bearings in my bosses 08/09 420 today, when I was refitting the swing arm I noticed a second set of holes on the frame about an inch below the mounts. What are these for?
I did consider bolting it back together using the lower holes to see if there was any noticeable differences other than a slight lift, I decided against thatbin the end and put it back together as it should be.


See less See more
1 - 1 of 6 Posts
can't say ?, I've only seen early 420 models, no late models, sooo..have no idea about those holes ?, but it does look like it was made to give it a lift ?.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.