TRX300FW rear diff rebuild

3621 Views 5 Replies 5 Participants Last post by daerhldgs2, Dec 17, 2009

bartjeep

Discussion Starter · Nov 30, 2009

Does anyone know the pinion preload setting on the rear diff? I guess I also need the backlash specs. The manual I bought for the ATV said that setting up the rear diff was a very complicated procedure and special tools are needed. Obviously, the manual is of no use in this case.

I have the tools I need and have set up many diffs for jeeps and cars...just need help with the specs.

Can anyone help?

thanks!

Save

1 - 1 of 6 Posts

daerhldgs2

· #6 · Dec 17, 2009

If you have between 6 and 12 thou lash youll be fine. there are washers to get the crown gear the proper distance from the pinion gear, but the pinion seems to only have one way with no way to set it deeper. I just shimmed my crown gear to get the right lash and it seems fine.

Save

1 - 1 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month