Honda ATV Forum banner
1 - 1 of 10 Posts

· Registered
396 Posts
I ruined a new seal yesterday trying to install without a press. It looks like I'll need to find a press to change the axle bearing on the Brake pad end of the d/s. and seals. I just priced some hydraulic presses and whoa, sticker shock. I didn't realize how much they can cost. May have to invest in seal install kit and check out some how too videos.
Watch Craigslist and local papers- it isn't too hard to find shop presses for reasonable prices. I found a profession, air over hydraulic press, plus a 16 ton tubing bender- both practically new- for $400. Some of the best money I've spent.
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.