Trip to the shop

3737 Views 15 Replies 5 Participants Last post by Helmut, Mar 17, 2010

Timpark

Discussion Starter · Mar 16, 2010

Ok so I went to my local shop and asked about my piston and rings and he told me that wiseco does not make a standard size for my 250x that I would have bore it to the next size in total it will be *$270 he also said that my cylinder was fine with just a hone and that something had to be done to the rings so they won't touch when they get hot but I found a standard wiseco and gasket kit for 140 so what should I do remember I only have 400 bucks in it

1 - 5 of 16 Posts

Timpark

Discussion Starter · #3 · Mar 16, 2010

I don't think I'll go back to that dude but what has to be done to the rings or was that just bs

Timpark

Discussion Starter · #7 · Mar 17, 2010

Thanks guys would any one know that spec and the valve gap spec and I think that will do it till the next thing

Timpark

Discussion Starter · #12 · Mar 17, 2010

It's a 87 and thanks again this is the best place for info

Timpark

Discussion Starter · #15 · Mar 17, 2010

Yea I all ways do it my self I pretty much know this thing inside and out

1 - 5 of 16 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.