[blitz]

Any one know the ID and OD of the swing arm lock nut wrench tool for my 2000 250 recon??? I'l try to make one if I can get the measurements! Thanks.

 

[blitz]

I made on from a piece of 1" black iron pipe. I threaded a sleeve on it very tight then welded it together and added an old 1/2" drive socket inside and welded it. Using my sawsall I cut away , from the open end of the sleeve, all but 4 "tits" that I measured very carefully and it works just fine! It took me about 1/2 an hour, and saved me the $55 they cost!!!

 

[mud99]

Thats great. That is a tool I'm going to have to come up with in the future.