Honda ATV Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Super Moderator
Joined
·
180 Posts
Discussion Starter #1 (Edited)

Get Ready! The May 2019 Honda ATV of the month contest is starting RIGHT NOW! This month we are looking for the best photo that features your Honda ATV. So get out there, get creative, enjoy some safe riding and take some photos! We welcome everyone including vendors to participate. The winner of the contest is decided by you the community, so stick around for the voting process.


  • The photo must be posted in this thread.
  • Only one picture will be allowed, so make it your best!
  • You must be the owner of the Honda ATV.
  • Please include a description of your ATV with a list of all modifications and enhancements.
  • You can only win once every 12 months

Voting will begin around May 15th, and run to the end of the month. Once the voting ends we will publish the winning photos on the front page and the winners will also receive:

  • HONDAATVFORUMS Stickers OR A $25 Amazon, Cabela's or Bass Pro Shop Gift Card. Your choice!
  • Premium Membership
  • Your bike will be featured on the home page of the site
 

·
Super Moderator
Joined
·
4,389 Posts
07 gusseted frame(done by mudmotorsports)
05 custom mudmotorsports subframe
+2 alba a-arms(custom needle bearing upgrade)
+1 lonestar swingarm and double row carrier
Pivot works bearings on everything
T.M. designworks chain slider and rear slide and glide kit
Elka legacy stage 3 long travel front and rear
Gt thunder xc link
Rpm dominator II axle
Blingstars brake rotor guard
Atv specialties double sprocket guard
RK x-ring chain renthal sprockets 13/38
Moose sprocket guard
05 trx450r spindles and brake calipers
Galfer brake lines
HMF full pipe, xc front bumper and xc low 450r grab bar
Houser pro bounce nerf bars
Kasedplates composite skid plate
Dwt rokout front rims with maxxis razr 2 tires
Alba racing beadlocks rear with maxxis razr xc tires
Mud motorsports custom hump seat cover
CCP steering stabilizer
Uni filter with ehs power lid
07 yfz450r FCR 39mm carb. R&D powerbowl 2 and flex fuel screw
^^^alot more custom work in this carb^^^
Wiseco 11:1 87mm piston fly cut for valve clearance
+1mm kibblewhite intake and exhaust
Titanium retainers and high rev spring kit
Stage 2 magnum cam
Crf450 timing chain
Gt thunder hd studs
Lightened flywheel
EBC dirt racer clutch 20% stiffer springs
4 inch spal fan on oil cooler
Air shrouds
Oil temp dip stick
Cometic gaskets
Motion pro cables
MSR ez pull clutch lever
Moose ez push throttle housing
Acerbis rally hand guards
Fasst Flexx 12° bars
Oury pillow grips
Mod quad dash and riser
Trx450r vented hood
Cycle1 hmf graphics kit
Race cut wire harness
Pro armor teather switch
Custom ram air intake setup
And there is no doubt im missing something.


https://www.hondaatvforums.net/forums/members/slammedranger-albums-winter-rebuild-continued-picture15790-videocapture-20190226-225806.html

 

Attachments

·
Registered
Joined
·
27 Posts
Let's try this again!
 

Attachments

1 - 4 of 4 Posts
Status
Not open for further replies.
Top