Honda ATV Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter #1
I am going to buy some vinyl and reupholster me seat but I want it to look original with the Honda logo on the back, I have heard of some people using spray paint And stencils but not sure how well that would work.

Any other ideas would be appreciated, Thanks!
 

·
Super Moderator
Joined
·
5,956 Posts
You can buy seat covers on ebay that are stenciled and have the OEM look stitched seam at the back already for less than 40 bucks. Last I priced them was two years ago... they were only $29.95 shipped back then. There are a few good reads on here about how to put new covers on so that they are pre-stretched right too. Search for 'em if interested.
 

·
Registered
Joined
·
61 Posts
Discussion Starter #3
You can buy seat covers on ebay that are stenciled and have the OEM look stitched seam at the back already for less than 40 bucks. Last I priced them was two years ago... they were only $29.95 shipped back then. There are a few good reads on here about how to put new covers on so that they are pre-stretched right too. Search for 'em if interested.
I’ve been looking at them and hate how the ones with the logo have the stitches in the side, I’m just going to buy a piece of vinyl, heat it up then stretch it to the seat and staple it for $25.
 

·
Registered
Joined
·
61 Posts
Discussion Starter #4
You can buy seat covers on ebay that are stenciled and have the OEM look stitched seam at the back already for less than 40 bucks. Last I priced them was two years ago... they were only $29.95 shipped back then. There are a few good reads on here about how to put new covers on so that they are pre-stretched right too. Search for 'em if interested.
Never mind what I said, I talked to a few of my friends in the USA and they have some older Honda’s. Asked them about the seat covers they had and they had the ones off of eBay.

Long story short I ordered one off of eBay
 
1 - 4 of 4 Posts
Top