Honda ATV Forum banner
1 - 1 of 3 Posts

· Registered
19 Posts
Discussion Starter · #1 ·
I need to replace the shift control motor. The service manual says to coat the control motor splines with a molybdenum oil solution. What is this? I usually coat splines with an anti seize lubricant (permatex). Is this ok or should I use regular grease or oil?

Also, do I need to perform the initial settings procedure after I replace the motor? I did unplug the ECU connectors.
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.