Honda ATV Forum banner
1 - 2 of 2 Posts

· Registered
12 Posts
Discussion Starter · #1 ·
I just recently replaced the u joint on my 07 420 rancher. When i dropped the swing arm, oil came from the final drive casing on the axle. after i replaced the u joint and got everything put back together, i noticed there is a gap between the shaft and the casing. I dont think it is supposed to be that way

Anyone have any ideas? Thank for any help. I think i may be missing an oil seal or something. I have cranked it and riden it around slowly and it seems fine just want to be sure...
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.