Honda ATV Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
I took my exhaust header and muffler off to clean the rust. I got a new muffler header gasket (the copper/brass circle piece), but don't know if I need to put a sealing gasket on the exhaust pipe joint piece? I just want to make sure it's put on properly so I don't have to remove it again. It didn't have any gasket on it when I took it off. This is on a 1987 TRX200SX
 

·
Premium Member
Joined
·
38,518 Posts
most call for a copper sealing crush gasket in the head, then a gasket where the muffler mounts to the header pipe at the clamp.
 
  • Like
Reactions: chasdabigone
1 - 2 of 2 Posts
Top