Honda ATV Forum banner

Rancher tire size

2216 Views 6 Replies 5 Participants Last post by  YukonXL04
Looking at new tires for a 2000 Honda trx350fm. Looking at kenda bear claw 299. I have seen a lot of tire questions go south, due to individual preference! Question is, each 25" tires is approx. 3 lbs heavier than the 24". So would the weight along witch the 1" height make a noticeable difference in performance (power/gear ratio and such) or should one just stick with stock size? I have tried to find weight of factory tires but have been unsuccessful.
1 - 1 of 7 Posts
I have a 2000 trx350fm and found a set of rims with tires off a 2002 bombardier quest 650. The rims have 4/110 lug pattern and appear to have close to same offset. I haven't been able to locate any rim off set info on them and cannot measure. Front tires are same just a inch taller, not sure rears would work they are a inch taller and 2 inches wider. Appreciate any advise or info anyone has.
The only width problem you might have is it hitting the heat shield on the muffler. I have 25x13x10 on the back of my rancher and it hit the heat shield. Took the shield off and all good.
I run 25x10x12 in the front
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.