Honda ATV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
7,154 Posts
Oh yeah I know, not my first rodeo lol. They can pop out it's not a big deal. Sometimes there isn't a ton of grease in them from the factory. I usually pop the seals off and pack them full, then replace the seals. The grease and seal seems to hold that inside race fairly well but I guess if your smacking it in the knuckle it might pop out. Typically I will leave the bearing in the freezer overnight and heat up the knuckle with a torch. Usually falls right into place. So yeah, run it, worst case scenario is the bearing fails prematurely and you have to replace the thing anyway.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top