Honda ATV Forum banner

Question for Shadetree or Helmut

1706 Views 16 Replies 6 Participants Last post by  shadetree
Yesterday I was reading the forum, but can't remember which section it was . But one of you guys said that your boss used this one parts dealer.It was not bikerbandit. I can't find this post to save my life. This distributor does not sell to the public you have to buy from one of there dealers. They had a great list of parts and numbers. That way I can order parts from one of there dealers that is located near me.I should have my butt kicked for not bookmarking that site. I sure hope you guys can help me out.
Thanks Dave C (clap)
1 - 5 of 17 Posts
Thanks Helmut. while I got your attention do I have to pull the pinion gear to replace the bearings in either side of the rear end. I got the bearing and 2 seals today in the mail for the backing plate on the brake side. 1 bearing , 1 large seal and 1 smaller seal. I hope thats right.Should have my axle nut wrenches on monday.
Clap
Sounds good, now if shadetree get back to me about that site , I can order the other 2 bearings and the seals i need. Thanks Helmut
Clap
Yesterday I was reading the forum, but can't remember which section it was . But one of you guys said that your boss used this one parts dealer.It was not bikerbandit. I can't find this post to save my life. This distributor does not sell to the public you have to buy from one of there dealers. They had a great list of parts and numbers. That way I can order parts from one of there dealers that is located near me.I should have my butt kicked for not bookmarking that site. I sure hope you guys can help me out.
Thanks Dave C (clap)
where you at shadetree
Thanks loads Shadetree
Clap
1 - 5 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top