Plastic installation problem

701 Views 5 Replies 4 Participants Last post by reddogge, Nov 5, 2017

reddogge

Discussion Starter · Nov 1, 2017

2016 Rancher and I can't seem to get the right side plastic back on after changing oil. I can't get two of the prongs back into the grommets. Also the black piece over the tank cover doesn't seem to have prongs to fit into the grommets in the front.

Save

1 - 1 of 6 Posts

Goober

· #4 · Nov 1, 2017

I use the silicone as the petroleum might degrade the rubber ( not sure if they’re oil resistant)

Save

1 - 1 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.