[mitchellkend]

Hey guys so I'm installing everything back in after a timing chain replacement of my fourtrax 350 just wondering how many o rings are suppose to be between the oil pump and the inside clutch side of the motor? I found one on the ground and after looking at the diagram I assumed it went in the spot on the oil pump that would line up with this o ring on the motor? Is that right or dose it belong somewhere else?

 

[mitchellkend]

For better reference dose this o ring in red belong in the green?

 

[retro]

Yeah, you got it right.

There is another smaller o-ring that goes between the oil pipe and the right-side cover (leads to the oil filter) as well. Don't forget that one... and remember there are three thrust washers that have to be in place before you put that cover back on.

Have fun!

 

[mitchellkend]

Retro any chance you can point the thrust washers out on a diagram

 

[shadetree]

Retro any chance you can point the thrust washers out on a diagram

I can tell you where they go. one goes on the kick starter shaft, one goes on the clutch arm shaft, and the last one goes on the reverse lever shaft .

 

[retro]

shadetree got ya covered... I don't have access to mine to show you, but section 9 covers everything under that cover pretty well. Its easy to make a mistake in there... hollar if you find yourself in a spot....