Honda ATV Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
102 Posts
Discussion Starter · #1 ·
I'm looking to get new beadlock rims but i'm not sure if I should get 3:2 or 4:1 offset. What is the offset on stock rims?? The new rim will be going on +2 standard travel a arms (idk if that helps choose offset or not) and also is hiper a good brand to go with?? Are they as durable as they say??
 

·
Premium Member
Joined
·
5,847 Posts
Hyper is a great brand! I personally do not own them, but my MX buddies all use them and love them.
I am not positive on your back spacing ???
I believe there is a post on this somewhere. I will look for it.
 

·
Premium Member
Joined
·
6,616 Posts
The off set is the distance in between the edge of the rim and where the hub bolts to the rim.

3+2 is the offset which means 3" of the total 5" width is on the inside of the hub and 2" is on the outside of the hub.

I would get 4+1. This will keep you right around 50". I love my hipers.

 

·
Registered
Joined
·
102 Posts
Discussion Starter · #5 ·
Rim and tire size

What about rim and tire size? I thought about keepin the front rims the same size but 1inch smaller in tire height and for the rear 1 inch smaller rim and tire
 

·
Registered
Joined
·
102 Posts
Discussion Starter · #7 ·
I ride trail but I also ( idk if this helps) do a ton of jumping...not sure if that matters
 

·
Premium Member
Joined
·
5,847 Posts
I have 22 inch Maxxis Razr on the front and 20 ITP mudlites on the back of mine. When I go to a MX track I have another set of wheels that are ITP MXR6 20 front and 18 rear. Both are on stock Honda rims.
 

·
Premium Member
Joined
·
6,616 Posts
Roughly $700 for my setup
 
1 - 10 of 10 Posts
Top