Honda ATV Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Just purchased a 2007 Rancher AT Gscape. The bike has 18 hours and 80 miles on it. Going to take it in for the 20 hour service. I checked the oil and it looked very clean but would only register when dipstick was screwed in. Measured half way between the low and full marks. Based on manual it is obviously low. Is this normal? Bike had been stored a while. Would this affect the oil reading?
 

· Premium Member
Joined
·
18,211 Posts
Well first of all ....Welcome to the forums. Second these engines are small and produce alot or heat so some disapation of oil will be noticed mine runs halfway too.
 

· Registered
Joined
·
1,855 Posts
Welcome to the forums!! I agree with moose 100% Also oil should be checked with the dip stick screwed in.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top