Honda ATV Forum banner

New clutch perch/lever

2203 Views 14 Replies 3 Participants Last post by  TRX2fiveO
Well I got the MSR lever on there. I like the "adjust on the fly" feature. That's pretty awesome. But what about this electrical thing that makes the clicking noise from where the stock lever used to be on there? Can I just snip those off? It's the two wires that come from the start/light thingy.
1 - 7 of 15 Posts
You need to connect them so you can start it.
I connected them together it will start in gear that is a safety switch that will not let you start it in gear with out the clutch being pulled in. If you connect them it will start in gear with out the clutch pulled. be careful.
Will it start in gear with them not connected?
They have Male plugs on the end right????
I am sorry female plugs that plugged in factory clutch perch
go out and see if it starts in gear. The new clutch perch has no hook up for the wires. They came off the old factory. THere are 2 wires with connectors that plugged to the old perch They have Female ends and the Factory clutch perch sould have the males and when it is hooked up if you pull the clutch the quad should start in gear. Atleast that is how mine was.
Right! If we are on the same page.
1 - 7 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.