[hondafam1]

I have a 2000 350FM, when you come to a stop and shift into Neutral, the neutral light does not come on. If you switch into reverse, then back to neutral, 80% of the time the neutral light comes on. The other 20% after switching from reverse, then switch into 1st gear, then into neutral the neutral light comes on. Of course if the light is not on, you can't start it.
Dealer said the neutral safety switch needs to be replaced for about $1,000.
Where is it, can I do it myself, it is hard to do, or can it be by-passed?
Any other ideas?
Thnaks for any help.

 

[MNRedneck]

Yikes! I would first start by double checking the wires to your indicators. Make sure the connections are good, and while your at it might as well put dielectric grease on the connections. Also check to make sure the wiring itself is ok. I'm not very familiar with the 350's, but IMO can't see why it should cost near that much.

 

[TRX2fiveO]

Welcome to the forums!
I agree ^^^^^ a grand is alot of franklins!! Pm Helmut he may be able to give you some more insight and even get you a picture or two..lol Good luck.

 

[Helmut]

Here is the gear position switch check and replacement procedures.

 

[newf344]

I had the same problem with my 01.I ran a toggle switch to the neutral wire harness.turn the switch and the light comes on and no problem But it will start in gear so be careful.Just check the wiring diagrams,good luck on your fix