[fishfiles]

soapy hot water I have read in numerous manuals is the proper way to remove machine shop grindings , I use G+H for my boring and on the break-in/ installation instructions that are sent along with the package , phara-phasing it says in a warning box marked WARNING : wash jug in hot soapy water , cleaning fluid may not remove all grindings from machine work done to jug --------- I am going to keep on washing mine with hot soapy water then blowing it off with air

 

[fishfiles]

Slamme'R , LOL , there is a 100 ways to skin a cat , as long as it taste good and there is no grit in your teeth , who cares how you skin't it !

I myself didn't like the idea of using water as water will cause rust , I am 60 years old and never heard of soapy water till maybe 2008 , but they scared me into it , it does a really good job of taking all the oil and grease off of it , so maybe that is a key , no oil or grease to hold grit , who knows !!! I do wash it out a lot , every hole , journal , passage way with hot water and Dawn dish water liquid , then blow it over with compressed air , if I feel one piece of grit I do it again , much like cat ! LOL