[agdodge4x4]

Mine must be a sport model. It has a bull bar type thing in the front but thats it. The undercarriage has 'pegs' with bolts in them as if there are racks available for it. Which front and rear racks will fit this model? It would make this less of a toy and more of a workhorse. Id prefer a direct fit, no welding required, even if I have to drill holes in the fender.

 

[SamUK]

Can you post a picture of the front end?

 

[WIRedRider]

There were a couple different ones available back in the day but finding them now might be tough. The first pic is of the Hondaline one I think. No drilling of the front plastic required. There was an aftermarket one that required drilling the plastic but I haven't seen one of those in a long time.

 

[SamUK]

Looking at that picture you'd probably be able to get a trx250a front carrier to fit with a little light fabrication.

 

[WIRedRider]

Looking at that picture you'd probably be able to get a trx250a front carrier to fit with a little light fabrication.

And you'd have a better chance of finding a used one of those.

Sent from my LGUS992 using Tapatalk

 

[agdodge4x4]

Oh man...those racks would be super awesome.

A TRX250A...would that be a 1985-1986 vintage?

Here is my Quad:

https://goo.gl/r3oP4s

Almost nothing in terms of front...just a grab bar. There is nothing on the rear except something very similar.

I found this rear one on ebay: http://www.ebay.com/itm/1985-87-85-...ash=item25be91ae06:g:DSAAAOSwepJXZ~5Q&vxp=mtr

But Im not sure it will fit without a bit of work?

 

[WIRedRider]

Yes on the 250A years. Specifically, 1985-87.

And yes on the rear rack needing some engineering. I've seen several pics online of obviously cobbled up ones. Some bad... Some not so bad...

Sent from my LGUS992 using Tapatalk

 

[SamUK]

@agdodge4x4 would you like measurements of trx250a carriers? I can take some tomorrow for you if that will be of any help?