1986 Honda Fourtrax 350. After setting for several days especially in cold weather the engine had to be cranked on and off over several times and finally would hear the fuel pump briefly click few times and it would start. Would not ever start until the fuel pump eventually ran. The fuel pump normally only operates on this model unit when the engine cranks or is running. Choke is operating ok also, just not getting enough fuel pump prime to the carb.
I noticed if I applied 12v to the fuel pump run wire manually for a prime until the fuel pump stopped clicking the cycle would immediately start. I installed a fender mounted primer switch like this one (see ebay number below) fused at 10 amps and works great. Cycle will now set for long time and immediately cold start after getting the manual fuel pump prime.
Note this switch is wired to apply 12v to the pump hot wire only after the normal regular feed wire is disconnected. (no backfeed thru the cycles regular wiring)
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
Honda ATV Forum
We’re a forum community dedicated to Honda ATV owners & enthusiasts. Come join the discussion about upgrades and reliability for your Rancher, Foreman, Recon, FourTrax, Pioneer, and more!