Honda ATV Forum banner
1 - 1 of 16 Posts

· Premium Member
12,712 Posts
You spend more time cleaning up the mess than it takes to pack them by hand , and I doubt it does as good a job as by hand -----what would be nice is some type of Bearing Buddies on the front where you could pump grease into the bearings ----

I see a lot of people with tube type straight rear ends are now drilling and tapping holes into the axle tubes and pumping them full of grease , they say it keeps the water from getting to the diff seals and gets grease to the outer axle tube bearings , I think I may do that ---------
1 - 1 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.