Honda ATV Forum banner

installing horn

8182 Views 2 Replies 3 Participants Last post by  submarine 300
I have a 2009 Honda Rancher that I am installing a horn on. The horn has two terminals and the switch for it has one wire. any ideas?/
1 - 1 of 3 Posts
Run a wire from the hot terminal of the horn to the hot terminal of the battery. Run another wire from the ground terminal of the horn to the switch. I would put an inline fuse in the hot wire. Evidently the switch grounds the circuit.
Looks like it would have to be a grounding switch with only two terminals. Juat make sure you get a good ground between the switch and where you mount it.
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.