Installed a clutch now won’t start

1102 Views 4 Replies 4 Participants Last post by Goober, Aug 18, 2018

Megan Ludwig

Discussion Starter · Aug 17, 2018

My son put a Henson Clutch in his Honda 300 ex today put fresh oil back in put it all back together .First time around started perfect no problem we shut it off and than nothing you can hear it clicking but nothing happens.. It won’t start when it’s in Neutral either? If you rock back and fourth sometimes it would start but now nothing after a couple times of it being started. We have racked our brains all day trying to figure this out? Someone said something about the Rod that was taken out but not sure?Checked battery it’s good also the clutch is very lose barely any tension?

Save

1 - 1 of 5 Posts

retro

· #3 · Aug 18, 2018

If the solenoid and battery are good you might want to check that the negative battery cable (ground cable) is bolted tightly onto the engine near the starter motor. Check frame grounds too, in case your son disconnected any of them to take the cover off for clutch work.

Save

1 - 1 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month