Have you checked the boot that holds the carb to the motor for cracks - bad gasket?
Idle will not adjust down
Hello
I have a 2001 Recon 250. The idle screw will not do anything. I can close it off completely or open it up all the way and there is no change in the idle. It idles at around 2000 rpm unless I pull out the choke. With the choke out about 3/4 of the way it idles fine, but I should not have to do that. I took the carb apart and cleaned it. I made sure I could see through the holes on both jets when I cleaned them. Any ideas?
I have a 2001 Recon 250. The idle screw will not do anything. I can close it off completely or open it up all the way and there is no change in the idle. It idles at around 2000 rpm unless I pull out the choke. With the choke out about 3/4 of the way it idles fine, but I should not have to do that. I took the carb apart and cleaned it. I made sure I could see through the holes on both jets when I cleaned them. Any ideas?
1 - 2 of 4 Posts
Nice it was something simple. Thanks for the update!!
1 - 2 of 4 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda ATV Forum
We’re a forum community dedicated to Honda ATV owners & enthusiasts. Come join the discussion about upgrades and reliability for your Rancher, Foreman, Recon, FourTrax, Pioneer, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
