Honda ATV Forum banner

How to remove clutches on 96 300

20181 Views 24 Replies 6 Participants Last post by  96frtrx300
finally got to tear in to figure out what my problem was i had an engine vibration and a loud racket sounded like a chain and faster you went louder it got checked my timing chain and its tight and a 4wheeler shop told me could be clutches wearing out and i did find some clutch material so now im trying to get my clutch out and looks like i need a special tool?anyone know


See less See more
21 - 25 of 25 Posts
and the puller that my rancher calls for..( which i didn't use..hammer worked ) honda part number 07933-hb3000a..but..i'm sure this changes from atv to atv..go figure !
I didn't realize the centrifugal clutch had those threads on it either, until I looked close. You won't even notice them unless you look real close. That hub with the threads only sticks up about an 1/8 of an inch or so.
i never paid it any attention..seeing how i always just smack it with a hammer to remove them..oh well..hammer is cheaper
that puller i bought that says its fits fourtrax from 88-98 and replaces the factory part dont fit its too big
I need to replace the timing chain on 96 fourtrex 300 - the service manual says that after I remove the centrifugal clutch lock nut that I should discard it and replace it with a new one. Does anyone know the part number for the "Centrifugal Lock Nut" so I can order a new one.
21 - 25 of 25 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.