Honda ATV Forum banner
1 - 2 of 2 Posts

· Registered
117 Posts
Discussion Starter · #1 ·
I need some help, I am installing a 2000 lb superwinch on my 2013 recon. I have it all installed but I can't figure out where to put the little red wire that goes to ignition switch. I have installed winches on ranchers before and this wire tapped into a accessory wire but the recon doesn't have this. I would like to hook this up so winch only has power when key is on. Any help would be appreciated Thanks
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.