Honda ATV Forum banner

Honda Fourtrax 350 Rear Axle Installation

1961 Views 2 Replies 3 Participants Last post by  Jeepwm69
Hi all,

I am in the process of replacing a worn out axle in my 2001 Honda Fourtrax 350 ES 4X4. When I install the axle from the right hand side (brake drum side) until it is fully seated, there is not much thread to grab with the axle nut. I was able to move it back to the right a bit, but am now unsure how to align it properly. Any advice on how to do this correctly would be greatly appreciated.

Thank you

Attachments

See less See more
1 - 1 of 3 Posts
Did you put the bearing stop on the left side of the axle, before you installed the axle tube?
  • Like
Reactions: 1
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top