[grunter16]

Hi folks, newbie here just taking the time to say hello.

I have just purchased a 1981 ATC110, which I managed to get running today, but in doing so, I noticed that there is no kill switch on it! Does anybody know if there is an aftermarket one that will fit in the hole on the RHS plate where the original one went? May save me a bit of searching! Thanks,

 

[machinecrook]

Welcome to the forums Grunter! Good luck on finding your kill switch. Someone is bound to have some info about that.

 

[SamUK]

Welcome to the forum.

I don't know about your model ATC unfortunately, some very knowledgeable guys on here who I'm sure will be along soon to give you some advise.

 

[_Wilson_]

Welcome to the forums switch assy stop 35300-958-671

Located this one, i couldn't tell you if that's a good price or not, it was the cheapest

Honda 35300-958-671 Switch Assembly Stop | eBay

Even better price

http://www.ebay.com/itm/OEM-HONDA-K...ash=item51f9935714:g:9bIAAOSwZVlXuejG&vxp=mtr

 

[mrbb]

welcome to the site, and if this is your FIRST 3 wheeler, be EXtra SAFE< there is a reason they stopped making them, and it was due to too many crashes?? they tip easy if your not in the know on how to lean with them to stay up right!

post some pi's too, several guys here still like them too!

 

[grunter16]

Hi, thanks for the advice, ill see about getting a pic or two taken (its not a show model that's for sure!)

Does anyone have any ideas if there is an aftermarket exhaust that is available for them or if there is a model that fits? Mine is hanging off!

thanks

 

[SamUK]

Hi, thanks for the advice, ill see about getting a pic or two taken (its not a show model that's for sure!)

Does anyone have any ideas if there is an aftermarket exhaust that is available for them or if there is a model that fits? Mine is hanging off!

thanks

I don't know if any other models will fit yours but if you have a welder and some basic fabrication knowledge just about any exhaust can be made to fit.
If you go this route be sure to keep the header (front pipe) the same I.D as the original, the silencer will be fine within reason.
If it's just your silencer that is rotten you could try ATC250ES, trx250a, trx200, you may find the silencer off an ATC90 will be similar.

 

[jameslb]

Welcome to the site. Be very careful on a 3 wheel. Enjoy.

 

[grunter16]

thanks for your help folks, I suppose i'm going to have to play about with the welder and a pit bike muffler. Don't suppose anyone has the dia of pipe used on the exhaust handy for ordering up the muffler? (I am away from home just now so unable to confirm until I get back on 3rd July)