final drive repair

1456 Views 2 Replies 3 Participants Last post by Saber6, Sep 7, 2009

lbagley

Discussion Starter · Aug 30, 2009

Any idea on how to get the needle bearing out of the housing where the pinion gear shaft goes into? There appears to be a snap ring type of keeper, but there is only a small 3/16 diameter hole to view or try to move this.

Thanks

Save

1 - 1 of 3 Posts

Saber6

· #3 · Sep 7, 2009

lbagley said:
Any idea on how to get the needle bearing out of the housing where the pinion gear shaft goes into? There appears to be a snap ring type of keeper, but there is only a small 3/16 diameter hole to view or try to move this.

Thanks

Could you get a picture?