Honda ATV Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Any idea on how to get the needle bearing out of the housing where the pinion gear shaft goes into? There appears to be a snap ring type of keeper, but there is only a small 3/16 diameter hole to view or try to move this.

Thanks
 

·
Registered
Joined
·
1,873 Posts
Any idea on how to get the needle bearing out of the housing where the pinion gear shaft goes into? There appears to be a snap ring type of keeper, but there is only a small 3/16 diameter hole to view or try to move this.

Thanks
Could you get a picture?
 
1 - 3 of 3 Posts
Top