Honda ATV Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
My Rubi is throwing code 6. So I am testing the ecm 21p connector for resistance, as per manual. Is it possible to get an actual photo or diagram of the 21p connector that shows the actual colored wires? Manual calls for Bl/R & Gr/Y... I see Bl/R &Gr/Y comin off the angle sensor connector but not off the connector at the ecm. 😳 Stuck like chuck until I can figure out which wire(s) takes place of Bl/R. Any help would be greatly appreciated.
 
1 - 1 of 1 Posts
Top