Honda ATV Forum banner

Ebs mxs brake pads

3788 Views 23 Replies 6 Participants Last post by  TRX2fiveO
Im trying to put these new ebs pads on my 400 ex. i pushed the caliber piston in as far as it will go. The pads are to thick still. What can I do?
1 - 7 of 24 Posts
when i try to put the pads in the caliper there is not enough space. should the piston be all the way depressed? it will not go down any further??
helmut. does the piston go in as far as flush to the caliper? because mine is pushed all the way in that it will go. and it is not flush to the caliper. it sticks up a little.
i did that with the pin for parking brake. it did let it go in further after doing that but then it didnt go all the way flush. man this is frustrating. i read a review on these ebc mxs pads and guy said he had the hammer them down and then it was a tight fit still. what do you recommend?
k im gonna try the c clamp thanks
Good ill remove mine then too.. The C clamp worked! Well the pads are on and very tight. They will loosen after riding and burn away right?
Yes my park brake lever is on clutch. what kind do you reccomend?
1 - 7 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.