Yours has been sitting for quite a few years if Im correct? what's the matter with your carrier? have you tried tighteneing up the axle nuts on the brake rotor side that will tighten up the rear-end if the bearing are not shot.
I would go back with a stocker atleast you know what fits then.
ive been looking at this one but i see a couple lonestars for just a little more..i just cant afford to get the best but at the same time i dont want the worst either..if thats even possible,,what do you guys think about the one in the link? says its a direct oem replacement
well my funds caused me to wait a while before i could order my carrier but it worked out well,,east coast reloaded their carriers back on ebay and ran a 10%off deal,,so i got my new carrier for 103.50 with free shipping,,it was 115 last month..im stoked,, im gonna ride a wheelie til i run out of gas in a week or so
its just really low in gas its been 5 years of walking past it in my carport with 4 flat tires covered in dust and crap,,,dead battery,blown rear,etc,etc,,,im excited to get it going again,,you know the song,"dont know whatcha got til its gone",,man i love big hair rock,lol...but yeah ,,i kinda have that feeling i had when i was 18 back in 98 buying it new
lol ,i just re-read my above post,,maybe i left out a comma or so?? kinda sounds like im gonna ride a wheelie for a week straight lolol
hey guys im putting her back together but i had to drill out a bolt that broke during dissasembly,its the #16 in the link,,says its a stopper? is it there just to stop the carrier from sliding out if the clips break??