Honda ATV Forum banner

CANNOT identify needed hardware on rear axle - help?

3451 Views 17 Replies 5 Participants Last post by  shadetree
Honda diagrams of the trx200's frame and swingarm are of zero help so I hope I can glean some knowledge from y'all here.

I recently ordered another round of parts for my $20 scrapyard quad, this time a much needed new carb, and fuel petcock valve. However one thing is still in my way - NUTS AND BOLTS!

There is a flange nut and/or flange bolt on the rear swingarm/subframe that helps keep the two components properly mated and prevents flexing. (Near the rear sprocket)

The previous owner apparently removed or lost this hardware and improvised by jamming a single random bolt into the bolt hole and threaded two nuts onto it back to back.

This setup allows the frame/swingarm to flex/move, causing the chain to pop off every time you go over a bump or turn too tightly.

Can anyone help me identify this hardware in terms of which nuts and bolts are needed, and where they can be acquired? I apologise for my ignorance, this is my first time working on one of these little hondas, and my head is spinning!
1 - 1 of 18 Posts
1 - 1 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.