My help may be a little too basic for you, but here goes. I was just over at Partszilla.com and looked up the TRX200. What year is your TRX?? The diagram you need may be the Frame vs. Rear Axle.
CANNOT identify needed hardware on rear axle - help?
Honda diagrams of the trx200's frame and swingarm are of zero help so I hope I can glean some knowledge from y'all here.
I recently ordered another round of parts for my $20 scrapyard quad, this time a much needed new carb, and fuel petcock valve. However one thing is still in my way - NUTS AND BOLTS!
There is a flange nut and/or flange bolt on the rear swingarm/subframe that helps keep the two components properly mated and prevents flexing. (Near the rear sprocket)
The previous owner apparently removed or lost this hardware and improvised by jamming a single random bolt into the bolt hole and threaded two nuts onto it back to back.
This setup allows the frame/swingarm to flex/move, causing the chain to pop off every time you go over a bump or turn too tightly.
Can anyone help me identify this hardware in terms of which nuts and bolts are needed, and where they can be acquired? I apologise for my ignorance, this is my first time working on one of these little hondas, and my head is spinning!
I recently ordered another round of parts for my $20 scrapyard quad, this time a much needed new carb, and fuel petcock valve. However one thing is still in my way - NUTS AND BOLTS!
There is a flange nut and/or flange bolt on the rear swingarm/subframe that helps keep the two components properly mated and prevents flexing. (Near the rear sprocket)
The previous owner apparently removed or lost this hardware and improvised by jamming a single random bolt into the bolt hole and threaded two nuts onto it back to back.
This setup allows the frame/swingarm to flex/move, causing the chain to pop off every time you go over a bump or turn too tightly.
Can anyone help me identify this hardware in terms of which nuts and bolts are needed, and where they can be acquired? I apologise for my ignorance, this is my first time working on one of these little hondas, and my head is spinning!
1 - 1 of 18 Posts
1 - 1 of 18 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda ATV Forum
We’re a forum community dedicated to Honda ATV owners & enthusiasts. Come join the discussion about upgrades and reliability for your Rancher, Foreman, Recon, FourTrax, Pioneer, and more!
Full Forum Listing
Explore Our Forums
Top Contributors this Month
View All
oldskool83
37 Replies
THEHONDABUILDER
12 Replies
Eric the red
12 Replies
Recommended Communities
