Honda ATV Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
138 Posts
Discussion Starter · #1 ·
SO, I opted to check out my ball joints on this used project bike. Upon pulling the tie rods out, the right side is pretty badly bent. The ball joints have been adjusted about 1/2" long than the left side, so someone didn't know what they were doing. No clue on what caused them to bend, but it must have been significant because It takes a lot of effort to bend them back. They had a distinct "S" bend in them, which tells me someone attempted to straigten it in the past. Anyway, I need to replace it and I see some used ones on ebay. Does anyone know of any NEW ones I can use for this quad? Anyone make any aftermarket ones for it?

I see a brand named Caltric, but it looks like Chinese junk.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top