Honda ATV Forum banner

Ball joint replacement

1617 Views 4 Replies 4 Participants Last post by  fishfiles
Anyone have any good videos or advice on replacing the ball joints on a 2004 Honda Rancher 350?

I can get them out, but trying to figure out how to put new ones in without damaging the boot.
1 - 1 of 5 Posts
Easiest way is to find a socket that fits over the boot and catches the steel lip or use a piece of steel tube. Suppose you could use box section too. I always clean the hubs throughly and apply a light coat of grease or oil for ease of fitment.
  • Like
Reactions: 1
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.