Honda ATV Forum banner
1 - 4 of 4 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
Pulled motor on my recon to change the top end gaskets and retap one of the 6 mm bolt into the crank. After putting it all back together. I have air, fuel, and spark but it will not attempt to start or anything just spins over and over. Any advice would be great. Did not split the crankcase apart.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.