96 300 fourtrax timing chain replacement help

24654 Views 3 Replies 2 Participants Last post by Helmut, Aug 6, 2010

bwy233

Discussion Starter · Aug 5, 2010

Whats the easiest way? Since my rebuild with a 1st overbore and i had it bored to match. I then lapped the valves and thats about it. Runs good but is god awful noisy like the timing chain is slapping against the case. Tensioner works fine and the guide is installed. I just dont know what else it could be other than a worn chain.

Save

1 - 2 of 4 Posts

bwy233

Discussion Starter · #3 · Aug 6, 2010

my only question is about the tensioner installation. I "can" install the tensioner with out turning the screw at all. IS this normal to be able to do that? I also tried turning the screw to suck it in and release after the install and that didnt help either.

Save

1 - 2 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.