Honda ATV Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
Ok, i have a 2009 420fa 4x4. I bought it running but smoking and wouldn't move. Tore engine down to find bad crank and other issues. Installed new crank, oil pump, timing chain, top end, and both clutch assemblies. Put all back together, ran great for about 15-20min. Then would not move again. I talked to local shop and they said maybe i smoked plates by not soaking them in oil for 24hrs. So i bought all new friction and steel plates oem and tried again, still will not move. I am using honda 10w30. It will shift into gear and show "D" but just barely tries to move. No lights or codes
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top