Honda ATV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
I have a question that I'm hoping to get an answer for. I have an '09 420AT and I put a set of factory Rincon rims along with a set of new Bighorns on my bike. The only fitment problem is the front wheel studs are shorter than the rears. I can still see 2 of the threads inside the nut. My question is, did anyone out there ever count the number of threads engaged on a set of aftermarket rims with cap nuts. The NHRA states that you need an engagement equal to the diameter of the stud. For a M10 x 1.25 stud that means 8 full threads engaged. I have nine. Good enough for them, good enough for me?
 

·
Registered
Joined
·
1,974 Posts
I did the same thing for my dads 09' AT. The tips of the stud do stick out, but they will not come loose or effect the performance at all.
 
1 - 2 of 2 Posts
Top