Honda ATV Forum banner
1 - 1 of 1 Posts

· Registered
11 Posts
Discussion Starter · #1 ·
Hello all,

I'm in the middle of a project with my Yamaha Raptor 350 which includes an EFI conversion and turbo charging it. I'm using the throttle body off of a 2013 Rancher 420. It so happens to fit the Yamaha intake boot perfectly and for $40 for the entire TB I could not pass it up.

What I'm looking for is the part number for the Idle air control valve or if someone has an old harness I could buy the connector with a few inches of wire on it.

Here is the thread to my build with a lot of good info on the rancher 420 TB sensors.

Raptor 350 EFI and Turbo build thread - Forums


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.