Honda ATV Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
147 Posts
Discussion Starter #1
will the rear fender plastics of the 400ex fit on the 250ex cause I like the look of the black on top of the red fenders in the back and was wanting to do it to my 250ex?
 

·
Registered
Joined
·
141 Posts
I am sure they will,to retain a factory look you may want to fab a set of hangers for them,not to hard with a small mig welder.
You may have to run the 400ex seats also.
If you have a donor bike this should be a very simple mod.
 

·
Registered
Joined
·
147 Posts
Discussion Starter #3
Atlanta, I don't have a donor bike, but would I have to run both the pieces of the rear fender set the upper and the lower piece or could i just buy the upper black piece that lays on top and just put them on mine?
 

·
Registered
Joined
·
141 Posts
I am not sure on that,it may lay ok then again may not come close.
I would look at the entire rear plastic and make some hanger.

Not all that hard really.
 

·
Registered
Joined
·
147 Posts
Discussion Starter #5
okay thanks i might have to do that after I get done making my quad wider. then I will look and the doing some body mods thanks.
 
1 - 5 of 5 Posts
Top